SLITTING & CUT-TO-LENGTH EQUIPMENT

SPECIFICATIONS:

“SWINGER TYPE”
Capacity: 50,000 Lbs.
Width: 54”
Max. Gauge: (3 Cuts of .375”) estimated
Speed: 350 FPM
Hand of Operation: Right to Left
EQUIPMENT SUMMARY
3 Coil Storage Ramp Double Cone Style Uncoiler:
With coil elevator
Driven Overarm Holddown Roll
Coil Feed-Up Drive and Peeler
6” Shaft both sides estimate 50,000 Lbs. Capacity
Upcut Shear:
58” Blade / Hydraulic
Automatic Edge Control:
Slitter (Loopco Swinger Design):
25 HP A.C. Feed Updrive
Single point adjustment on upper arbor
9” Arbors
(2) Heavy Duty Braner Scrap Winders:
5,000 Lbs. Capacity Each
54” x 50,000 Lbs. Loopco Slitting Line
Page 2
Peeler / Elevator Table to Recoiler:
Hydraulic Tension Stand manufactured by Royalton:
Recoiler:
200 HP with Heavy Duty Right Angle Gear Reducer
56” x 20” Recoiler Drum (Estimated 50,000 Lbs. approximately)
12” Diameter arbor through the bearing.
Hydraulic Coil Push-Off
Overarm Separator
Single Arm Turnstile:
With Hydraulic Push-Off
Slotted for “C” Hook
500 HP Reliance Drive Maxline Solid State Drive:
500 Volt
Spare Parts:
2- New never used Arbors
1- New Recoiler Drum
2- New Cones for Uncoiler
1- Spare Arbor for Scrap Winder
Large quantity of knives, spacers, and rubber stripper rings.
Note: This slitter is in very good condition and it is very heavy 
duty.



PRICE....................:  SEND A QUOTATION!!!